Menu Close

Call Now: 1-855-790-8416 Available 24/7

Fire Damage With Smoke & Soot Cleanup

– High pressure water blasting leaves behind water in electrical elements, equipment and insulation, if not correctly removed will cause unwanted corrosion and rot, increasing clean-up, damage and long-term repair and maintenance costs.

II. How do we remove the charcoal, smoke and soot film from masonry and steel surface areas?

– Again this is an excellent application for dry ice blasting. Watch the movie clips on our web site to see how dry ice blasting cleans soot, smoke and charcoal from different types of surfaces.

IV. Can we achieve our clean-up without adding dangers to our environment?

– Dry ice blasting is environmentally friendly and safe. Dry ice is pure CO2 in its solid state, it is in its gaseous state in the air around us.

You’ve had a fire. The fire department has arrived, put the fire out and all you see is one big wreck.- Dry ice blasting is environmentally friendly and safe. Dry ice is pure CO2 in its solid state, it is in its gaseous state in the air around us. Green plants take CO2 from the air and give off oxygen.

You have had a fire. The fire department has arrived, put the fire out and all you see is one big wreck. Upon closer inspection concerns come.

– During a fire air currents transport smoke and soot into openings, areas and cracks not in close proximity to the fire itself, additional cleaning and/or sealing of these places and inaccessible areas may be needed.

– Dry ice blasting is the ultimate surface cleaning procedure, it leaves behind no additional waste stream behind. The only clean-up after the dry ice blasting project is done is the removal of the debris brought on by the fire.

– Dry ice blasting is non-toxic, non-conductive and there is no employee exposure to hazardous cleaning chemicals or solutions. Dry ice blasting meets the guidelines of the USDA, EPA, and the FDA.

I. What strategy do we use to remove the soot and charcoal to assess the destruction?

– Soda blasting leaves water and soda behind, which requires additional cleanup, increasing clean-up, damage and prolonged routine maintenance costs.

III. Will we have the ability to remove that awful smoke odor?

– Sand blasting leaves abrasive blast media behind, which if not cleaned up properly continues to cause damage in electrical elements, bearings and gears. It keeps on fall from horizontal surfaces, beams and cracks years after the task is completed, increasing cleanup, damage and long term
routine maintenance costs.

– The removing of the smell is accomplished by removing the smell source and/or sealing the smell source to encapsulate it. Dry ice blasting removes the charcoal, soot and smoke film, which is the smell source, from accessible areas.

For 24/7 local restoration service, call us at 1-855-790-8416. We’re here to help.